Teroson WX 210 - 500 ml wax anti-corrosion protection spray

TEROSON WX 210 is an anti-corrosion agent for area coating and for the protection of cavities, containing mild smelling solvents. It is a thin, slightly thixotropic spray which atomizes easily. The anticorrosion agent is bitumen free and has a strong neutralisation power and thus good acid binding capacity. The product contains a high proportion of rust inhibitors. The polymer portion leads to high toughness and relative high abrasion resistance compared to other wax products. TEROSON WX 210 is very finely atomized on spraying, has outstanding creep qualities, penetrates well into the spaces to be protected (e.g. welds) and yet does not run excessively from the bottom of such joints. Creep qualities are optimal if the product and the bodywork are at room temperature. When fully dry, the anti-corrosion agent forms a tough, plastic, water-repellent film of translucent thin layers. The aerosol can is equipped with two spray heads: one spray head with a tube, one spray head with a slit nozzle for area coating.

APPLICATION AREAS TEROSON WX 210 is used in workshops primarily as conservation wax for preventive protection and for care and repair. With the new type of fan jet spraying head underbodies of cars can be evenly coated with a widespread jet. The attached round jet spraying head with tube allows spraying in cavities on cars, e.g. doors, motor hoods, trunk lids and areas difficult to reach. TEROSON WX 210 is suitable for spraying the interior of open cavities, in addition to existing cavity conservation of new vehicles and follow-up treatment after accident repairs. The product is ideal for corrosion protection on sheet metal and steel parts, e.g. fuel tanks, brake tubes or tubes of the power assisted steering. Screw connections at gearbox crossrails and engine suspensions can also be coated with this translucent protection film. The thread is thus protected and will enable secure screwing. On modern cars TEROSON WX 210 completes the factory coating on transitions, under plastic hoods, in the weal houses and under the fenders. The splash water resistant film permanently protects concealed body areas. Body seams under bumpers which are no longer caulked in the factory can be securely sealed. TEROSON WX 210 is particularly suitable for long term protection of immobilized vehicles. The product is also used for the conservation of seams, areas and cavities on vehicles and rust endangered spots in the engine compartment. Slightly sprayed rubber parts will show a dull gloss and a fresh appearance. Building machinery, agricultural equipment and gardening implements, e.g. the underbody of lawn mowers, hoes and spades can also be excellently maintained and protected

TECHNICAL DATA (Typical Test Results)
Colour beige-translucent
Odour mild odour
Density approx. 0.85 g/cm³
Solid approx. 40 %
Consistency thin liquid. slightly thixotropic
Drop point of solid (DIN 51801) >100 °C
Sag resistance min. 100 µm Penetration >13 mm
Behaviour in the repair paint oven (1.5 hrs at 90°C) no running off
Corrosion resistance no corrosion salt spray test to DIN 50021 (35°C, salt solution 5%, 240 hrs)
Dry film thickness 50 µm
Application temperature 15 to 25 °C
In service temperature -40 to 100 °C
Short exposure (up to 1 h) 130 °C