QUALITY AND PROPERTIES

• Good coverage and filling power
• Long-lasting colour and shine
• Scratch, shock and impact proof
• Excellent adhesion to almost all materials
• Good corrosion protection
• Petrol, chemical and weather proof

PHYSICAL AND CHEMICAL DATA

• Basis of the binder: Alkyd resin
• Colour: transparent
• Smell: solvent
• Efficiency:
  Depending on consistence and color of the ground:
  400 ml are sufficient for approx. 1.25 - 1.75 m²
  depending on colour
• Drying time (at 20°C, 50% relative air humidity):
  Dust-dry: after approx. 30 - 60 minutes
  Tack-free: after approx. 3 4 hours
  Cured/Coatable: after approx. 24 hours
  The drying time depends on surrounding temperature, air humidity and thickness of the applied coat.
• Temperature-resistant: up to 110°C
• Storage stability:
  10 years, if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%)
• Size:
  aerosol can, maximum nominal volume 400 ml

INSTRUCTION MANUEL

Before use, carefully read and observe the warning texts on the label!

Pre-treatment for surfaces:

• Surface should be clean, dry and free of grease.
• Remove loose paint and rust, then sand and prime.
• Once the primer has dried, sand with 600-grit sandpaper.

Painting:

• The surface should be clean, dry and free of grease.
• Bring the can to room temperature.
• Operating temperature 15 to 25°C.
• Shake can for 2 minutes before use.
• Spray to test compatibility on an inconspicuous area.
• Spray from a distance of ca.25-30 cm.
• Spray on lacquer in several thin coats.
• During use, shake the can from time to time.
• After use, turn the can and spray the valve empty to clean.
• Even when thoroughly dry, do not spray with acrylic or nitro-combi lacquer!

TIPS FOR SPRAY PAINTING

Protect the object and the surrounding area from spray mist. When painting small areas it is recommended that a piece of card is used as a mask, with a hole cut in it slightly larger than the area to be sprayed. The mask should be held 1 to 2 cm from the surface. With this method, the mainly part of the spray mist is brought under control. It recommends to mask parts not to be lacquered, to protect the surrounding against the spray mist.

The aerosol can should have room temperature.

Temperature should range between +10°C and +25°C, max. air humidity 60 %.

Store in a dry place. Protect from direct sunlight and other sources of heat. Use only during dry weather, in places protected from the wind, and in well-ventilated rooms. Follow the warning texts on the labels!