Motip Deco Universal Primer gray spray 400 ml

With the primer, you add excellent adhesion to the next MoTip top coat with spray paints.

For treated and untreated surfaces of wood, metal, aluminum, glass, stone.

QUALITY AND PROPERTIES
High quality nitro-station wagon quality
Quick-drying
High coverage and fullness
Good corrosion protection
Good wet and dry grinding (grit 400)
Excellent grip on most surfaces
Can be painted with all coating systems

PHYSICAL AND CHEMICAL PROPERTIES
Binder base: Nitro-combi resin
Color: white, gray
Odor: solvent
Efficiency:
Depending on the consistency and color of the substrate:
400 ml is sufficient for approximately 1.25 - 1.75 m²
Drying time (at 20 ° C, 50% relative humidity):
Dust resistant: after approximately 5-10 minutes
Cured / recoating: after approximately 2 hours
The drying time depends on the ambient temperature, air humidity and the thickness of the applied layer.
Temperature resistance: up to 110 ° C
Storage stability:
10 years provided that suitable storage facilities are provided (= 10 ° -25 ° C, relative humidity max. 60%)
Size:
Aerosol, maximum volume 400 ml

INSTRUCTION MANUEL
"Most MoTip color sprays have a so-called snap ring or protective cap to prevent unauthorized use. See the appropriate advice on the cap or label.

Read and follow the warning texts on the label carefully before use! "

Surface preparation:
The surface must be clean, dry and free of grease.
Remove old varnish, peeling rust and sand the surface.
Pre-treat plastic parts with MoTip Primer.
Allow to dry for 1-2 hours.

Painting:
The surface must be clean, dry and free of grease.
The container should be at room temperature.
Ideal operating temperature 15 - 25 ° C.
Cover areas that should not be treated.
Shake the container for 2 minutes before use.
Test in an invisible place to see if the spray paint is compatible with the surface being treated.
Apply several thin coats from a distance of 25-30 cm.
Shake the container again before using another layer.
After use, turn the container upside down and press the valve to clean it.
After drying (2-4 hours), sand the surface wet with sandpaper (grit 600), clean the surface and let it dry.
Then apply the top coat.
After 2 hours another layer can be applied.

ENVIRONMENT AND LABELS
Environmentally friendly: European Aerosols products are 100% heavy metal free. Lids and packaging are made of recyclable materials.

Disposal: Dispose of mixed waste and contaminated packaging as hazardous waste. Cleaned packaging can be handed over for recycling.

Packaging marking: All European Aerosols products comply with current Czech and EU regulations concerning packaging marking. This is the current version of the following regulations:

Act No. 350/2011 Coll. on Chemical Substances and Chemical Mixtures and on the Amendment of Certain Acts (Chemical Act).
Regulation (EC) No 1272/2008 of the European Parliament and of the Council on classification, labeling and packaging of substances and mixtures (CLP).
Government Regulation No. 194/2001 Coll., Which lays down technical requirements for aerosol dispensers (in the case of aerosols)
Directive 75/324 / EEC (ADD) - in the case of aerosols
The safety data sheets for European Aerosols products comply with the REACH Regulation 1907/2006 / EC, Article 31, Annex II.