Alkyton Penetrator red 5000 ml

Special paint for painting surfaces damaged by deep corrosion. It penetrates into the corrosion, expelling the water and air contained in the corrosion. This prevents the corrosion from continuing.

Yield 14.5 m2 per liter with one layer (35 µm).

PROPERTIES AND QUALITY
Special base with solvents
For brush application
It creates an ideal insulating layer for a rusted surface

PHYSICAL AND CHEMICAL PROPERTIES
Binder: a mixture of specially treated fish oil and synthetic resins
Colors: red / gray
Odor: solvent
Yield: Theoretical: 14.5 m² / l / at 35 μm dry film
Practical yield depends on many factors such as surface texture and application losses
Drying (at 20 ° C, 50% relative humidity):
To touch: 4 hours
For handling: 8 hrs.
Fully cured: 8 days
Recoatable: after 24 hours
Density: 1.33 kg / ltr.
Viscosity: 76-78 KU 20 C °
Dry matter: 50.3% vol
Heat resistance: up to 120 ° C
Storage:
5 years from the date of production in unopened cans, when stored in a dry, well-ventilated area, not exposed to direct sunlight at temperatures between 5 ° and 35 ° C.
Recycling: Put the empty container in a waste container. Dispose of in a special hazardous waste center.
Packaging: max. Nominal volume = 250 ml, 750 ml and 5 ltr

PREPARATION BEFORE PAINTING
Preparation:
Remove oil, grease and any other surface contamination with alkaline product RO ND 14, or pressure cleaning in combination with suitable detergents
For optimal results, remove scale, loose rust and poorly adhering residues of old paint. Blast to grade Sa 2 1/2 (ISO 8501 - 1: 1988) If blasting is not possible, use a scraper and steel brush to grade St 3 (ISO 8501 - 1: 1988)
The surface must be clean and, if possible, dry during application
The penetrator tolerates application on damp substrates

Painting:
Stir the paint thoroughly before use

Brush:
Dilution of max. 10% thinner RO 633 (or S6005) To apply the required coating thickness, two brush coatings may be necessary. Use a brush with natural long hair

Roller:
Dilution of max. 10% thinner RO 633 (or S6005) To achieve the required coating thickness, two brush coats may be necessary. Use pearl rollers 8 -12 with medium-long hair
Air spraying:
Dilution of 10 -20% by volume with RO 641 thinner - in small amounts according to the equipment. Nozzle size 1.2 - 1.8 mm, pressure 2 -4 bar
Without air spraying:
Thinner RO 641 - in small quantities according to the equipment. Nozzle size 0.013 - 0.015 inch, pressure 130-200 bar
Cleaning:

Thinner S 6005

Application conditions:
Surface and material air temperature in the range of 5 ° to 35 ° C
Relative humidity: below 85%
Lowest substrate temperature: 3 ° C above dew point