DINITROL RC 900 Rust Converter Spray 400 ml

Characteristics:
DINITROL RC 900 is a Rust Converter with an organic chelat complex base and epoxy resin. DINITROL RC 900 actively converts rust on substrates into a stable organic iron complex. Once the product is dry, an impermeable barrier against further corrosion is formed. DINITROL RC 900 penetrates rust 7 − 10 times deeper than standard rust converters. DINITROL RC 900 forms a dry and strong adhesive film which is suitable as a base for paintwork and other corrosion protection products.

Areas of Application:
DINITROL RC 900 has been developed for use on oxidised iron parts.

Method of Use:
Remove rust, grease and dirt with a wire brush, sand paper or a sandblasting process. Rust and scale may only be visible as slight shading. In addition to rust, the steel must also be free from dust and grease. Carefully clean with acetone or lacquer thinner. Shake the spray can well. The product should be applied in several successive coats, at a distance of approx. 25 cm. The metal temperature should not be below 10°C. The material is dust-dry after one hour; if necessary, a further coat can be applied.

Technical data:
Colour: amber-coloured solution
Film type: hard
Density: 0.9 g/cm³
Viscosity: ~ 118 cm centistokes
Solids: 16%
Empfohlene Schichtstärke: 130 µm Yield: ~ 60 g/m² per coat
Drying time: 24 hours at 20°C
Storage time: 18 months (between 15°C and 25°C)
Package size: 400 ml spray

Danger
acetone 1-methoxypropan-2-ol
H222 Extremely flammable aerosol. H229 Pressurized container: may burst when heated. H319 Causes serious eye irritation
P101 If medical attention is needed, have product container or label at hand. P102 Keep out of reach of children. P103 Read label before use. P210 Keep away from heat, hot surfaces, sparks, open flames and other sources of ignition. No smoking. P211 Do not spray on open flames or other sources of ignition. P251 Do not puncture or burn even after use. P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if worn and if they can be removed easily. Continue rinsing. P410+P412 Protect from sunlight. Do not expose to temperature exceeding 50°C/122°F.