ColorMark LineMarker line marking spray white 750ml

pecial marking of lines and divisions for roads, parking lots and industrial plants as well as safety signs.

Colour hues: white, yellow, red, orange, green, blue, grey, black and traffic yellow. 

The grey and black marking sprays can also be used as corrective sprays to remove fluorescent markings from concrete or tar.

QUALITY AND PROPERTIES
High coverage, quick drying quality
Special valve for floor applications ensures sharp edges
Specially for use in Speedliner²
Containers: 500 ml and 750 ml
For permanent markings (durability of the marking depends on the surface as well as location (inside /outside) and daily burden)
Highly resistant to abrasion

PHYSICAL AND CHEMICAL DATA
Colours: white, yellow, red, orange, green, blue, grey, black, traffic yellow
Storage stability:
10 years if appropriate storage provided (=10°-25°C, relative air humidity max. 60%).
Efficiency:
Depending on condition and colour of the ground,
500 ml are sufficient for approx. 40 m of 10 cm wide lines
750 ml are sufficient for approx. 60 m of 10 cm wide lines
Drying (at 20°C, 50% relative air humidity):
Dust-dry: after approx. 10 minutes
Dry to touch: after approx. 30 minutes
Cured: after approx. 24 hours
Can be overworked: after approx. 24 hours
The drying time depends of temperature of surroundings, air humidity and thickness of the applied layer.
Contents: aerosol cans with max. nominal volume of 500 ml resp. 750 ml

USING INSTRUCTIONS
Before use, carefully read and observe the warning texts on the label!
Shake can for approx. 3 minutes.
After you hear the sound of the balls inside the can, vigorously shake the can for one more minute.
Test spray at an invisible spot.
Spray distance approx. 25 cm.
Apply the desired marking.
In case of use in the Speedliner² marking trolley, attend to the corresponding manual.
Mineral substrates must have set well, new concrete must be at least 4 - 6 weeks old
The substrate must be dry, clean, free of fat and stable, loose and sanding layers are to remove
Concrete and screed must still have sufficient apsorptive capacity to ensure adhesion

Danger
acetone
Hydrocarbons, C9-C11, n-alkanes, isoalkanes, cyclics, <2% aromatics
butanone
Hydrocarbons, C9-C10, n-alkanes, isoalkanes, cyclics, <2% aromatics
H222-H229 Extremely flammable aerosol. The container is under pressure: it may burst when heated.
H319 Causes serious eye irritation.
H336 May cause drowsiness or dizziness.
P101 If medical attention is needed, have product container or label at hand.
P102 Keep out of reach of children.
P210 Keep away from heat, hot surfaces, sparks, open flames and other sources of ignition. No smoking.
P211 Do not spray on open flames or other sources of ignition.
P251 Do not puncture or burn even after use.
P260 Do not breathe aerosols.
P410+P412 Protect from sunlight. Do not expose to temperatures exceeding 50°C.
P501 Dispose of contents / container in accordance with local regulations.
EUH066 Repeated exposure may cause skin dryness or cracking.
EUH208 Contains Fatty acids, tall-oil, esters with polyethylene glycol mono(hydrogen maleate), compds. with amides from diethylenetriamine and tall-oil fatty acids. May cause an allergic reaction.
EUH211 Attention! Hazardous respirable droplets may form when sprayed. Do not inhale aerosols or mist.
Explosive mixtures can form without sufficient ventilation.