Cold galvanization against corrosion. Excellent rust-protection for all iron metals, such as car bodies, exhaust systems, gates, machines, metal housings, metal fittings, fences etc. Especially suitable for the protection of welding seams and metals which are exposed to corrosion.

For the colour-matching repair of zinc-plated surfaces, use  MoTip Alu Zinc Spray.

QUALITY AND PROPERTIES

• High-grade zinc coating with more than 90 % zinc share in the dry film
• Cathodic corrosion protection for all blank metals
• Resistant to highest demands against corrosion
• Highheat-resistant up to 350°C
• Fast-drying
• Particularly suitable for welding seams  
• Ideal for all metals in outside places, which are liable to rust
• Mat surface
• Resistant to petrol, chemicals and weather influences

PHYSICAL AND CHEMICAL DATA

• Basis of the binder: Epoxyester
• Colour: grey
• Smell: solvent
• Degree of gloss (at measurement angle 60° acc. to DIN 67530):
  matt: 0-5 gloss units
• Efficiency:
  Depending on consistence and color of the ground:
  400 ml are sufficient for approx. 1.25 - 1.75 m² at covering layer
• Drying time (at 20°C, 50% relative air humidity):
  Dust-dry: after approx. 10-15 minutes
  Non-sticky: after approx. 20-30 minutes
  Resistant to temperature: after 8-12 hours
  The drying time depends on surrounding temperature, air humidity and thickness of the applied coat.
• Temperature resistant: up to 350°C
• Storage stability:
  10 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%)
• Size:
  aerosol can, maximum nominal volume 400 ml

INSTRUCTION MANUEL

Before use, carefully read and observe the warning texts on the label!

Preparation of the ground:

• The metal surface has to be blank and free from fat.
• Lose Altanstriche und Rost entfernen, evtl. anschleifen.
• Due to the high density, the Zinc Primer has to be shaked for at least 2 minutes after you hear the noise of the mixing-balls. Otherwise the valve could block.

Lacquering:

• Test spray at an invisible spot.
• Spray from a distance of approx. 25 - 30 cm.
• Apply several covering coats.
• After drying (approx. 24 hours) apply primer and top coat.
• Do apply just thin coats to objects, which are exposed to high heat. If necessary, re-coat with temperature-resistant lacquer (test painting).
• It is not recommended to overpaint with other laquers.

TIPS FOR SPRAY PAINTING

Protect the object and the surrounding area from spray mist. When painting small areas it is recommended that a piece of card is used as a mask, with a hole cut in it slightly larger than the area to be sprayed. The mask should be held 1 to 2 cm from the surface. With this method, the mainly part of the spray mist is brought under control. It recommends to mask parts not to be lacquered, to protect the surrounding against the spray mist.

The aerosol can should have room temperature.

Temperature should range between +10°C and +25°C, max. air humidity 60 %.

Store in a dry place. Protect from direct sunlight and other sources of heat. Use only during dry weather, in places protected from the wind, and in well-ventilated rooms. Follow the warning texts on the labels!